Crane cams hyd roller lifters

[Supershafts]

Has anyone used these rollers and actually adjusted them as per cranes spec's ..... 1 full turn

[mikelbeck]

Yep, I use them on my motor.

I set 'em for zero lash, then go 1/2 to 3/4 turn. I feel when I got 1 full turn it's too tight.

BTW, I've broken a couple of these rockers... Well, the rockers getting broken was a by product, I had the adjusting screws go bad, loosen up and the pushrod ended up beating the crap out of the rocker. Crane did replace them for free, and sent along a whole set of adjusting screws as well.

[Supershafts]

No not the rockers, the rollers...

I am having issues with the rollers i have never ever put the pre load and then went 1 full turn more...that's like 050 to 070, but there telling me to do this....but if something happens you know they'll say i didn't _______

[mikelbeck]

No not the rockers, the rollers...

Ah. Sorry, should've read the message better. ;-)